 |
| S2-400 Maxi-Stamper (400 Ton) |
| Available in 200 through 1000 ton capacity, the Maxi-Stamper represents the cutting edge of press engineering and design. The Maxi-Stamper line of straight side presses exceeds the heavy stamping industry's demands for production, speed and efficiency. Maxi-Stampers are used by automotive suppliers in transfer and progressive die setups. Heavy gauge material used for seat belt components show off this press's ability to withstand the toughest jobs. High end tool and die shops prefer the consistency of the Maxi-Stamper for making quality parts during die testing. Available in one, two and four point eccentric gear drive configurations, the Maxi-Stamper will help contribute to the growth of your company by providing consistent quality part production for many years to come.
The press is of fabricated steel design. The crown, bed and slide are welded steel plate of box type construction. The four heavy steel tie rods pass through the frame structures and are pre-stressed with a hydraulic device to hold the structure in place. The pre-stressed tie rod construction insures proper die alignment during high tonnage stamping.
The bed of the Maxi-Stamper is reinforced with massive cross ribs for maximum rigidity. The ridged construction and thick bolster ensure a maximum of .0015" deflection per foot of width at full load on a tool covering 66% of the bed area, equally spaced on the left to right and front to back press center line and a maximum deflection of .0015" per foot of length on the front to back center line.
Wide non-metallic (phenolic) way liners are bolted to the slide for easy adjustment. The eight point square type gib arrangement allows for adjustment of the slide in front to back and right to left directions. Extra long gibs retain the slide fully in any position of stroke and adjustment.
|
| |
 |
| Model S1-500 Maxi-Stamper (500 Ton) |
| |
 |
| Model S4-800 Maxi-Stamper (800 Ton) |
| |
|
| 200-1000 Ton Heim Maxi-Stamper Single, Two and Four Point Straight Side Presses |
| |
| Standard Features |
-All Welded Steel
-Bed Deflection Rated at .0015 per foot
-Pre-Stressed Tie Rod Construction
-Drive Capacity Rated 1/2" Above Bottom of Stroke
-Combination Air Clutch and Brake
-One, Two and Four Point Eccentric Gears and Helical Intermediate Gears
-Hydraulic Overload System
-Bed Areas up to 168"X84"
-Ball Type Adjustment Screw with Bronze Seat
-Adjustable Full Length 8-point Square Gibbing
-Recirculating Lubrication System
-Air Counterbalance System
-Bolster Plate
-Power Slide Adjustment with Digital Position Indicator
-Stroke Counter
-Solid State Press Control in a Floor Mounted Console (ANSI B11.1)
-Motion Detector and Brake Monitor
-Forward/Reverse Feature
-Eccentric Geared Drive
-Above Floor Construction
-Start Up Service |
| |
| Optional Features |
-T-Slotted Slide and Bolster
-Automatic Slide Adjustment
-Variable Speed Drive
-Automatic Counterbalance
-Tonnage Monitor
-Automatic Speed Control
-Additional Programmable Cam Limit Switches
-Feed Interface
-Die Protection
-Die Cushions
-Pedestal Mounted Operation RUN Stations
-Custom Speeds
-Isolation Pads |
| |
|
